基于回转输运试验的煤散料离散元接触参数修正

为获取精确的刮板输送机离散元模拟结果，基于回转输运试验，通过响应面法对煤料的接触参数进行修正.采用Plackett-Burman试验考察接触参数对受力及堆积角的影响，发现煤-钢静摩擦系数、煤-煤摩擦系数具有显著正效应.根据爬坡试验结果，以受力及堆积角为响应值规划Box-Behnken试验，建立受力、堆积角与显著项间的二次回归多项式，以实测数据为目标值求得最佳参数:煤-钢静摩擦系数为0.401，煤-煤静摩擦系数为0.333，煤-煤滚动摩擦系数为0.041.通过不同输运条件下的回转试验验证了参数的准确性，为刮板输送机的离散元研究提供参考.     

硬线控制冷却工艺

研究了影响硬线性能的主要工艺参数，这些参数是决定线材最终产品质量的关键，并初步讨论了其影响规律。     

HF-Ⅰ新型改性酚醛树脂研制及性能评价

以苯酚、甲醛、环氧树脂、聚乙烯醇等为原料在酸性催化条件下 ,研制成一种新型环氧改性酚醛树脂 ,通过性能评价并从砂轮、切割片的应用表明。该粘合剂粘结性能、强度、韧性均达到国内同类产品先进水平 ,制做的砂轮、切割片性能优良。     

抽油机井系统效率极限值的仿真研究

以油井供产协调方程为基础,建立了抽油机井动液面、产液量与抽汲参数之间关系的仿真模型,改进了以抽油杆柱动态仿真为基础的抽油机井系统效率仿真模型,并建立了基于抽汲参数优化设计的系统效率极限值仿真模型.分析了油藏参数、油井参数、设备类型与抽汲参数对系统效率的影响.仿真结果表明:系统效率随油井产能的增加而增加;含水率与气油比对系统效率有显著影响,气油比越大、含水率越低,系统效率越低;抽汲参数组合对系统效率有显著影响.对于低气油比、高含水、高产液量的油井,在优化设计抽汲参数条件下,抽油机井系统效率极限值可以达到50%,甚至超过60%.目前现场实际测试中所出现的50%以上的高系统效率是有科学依据的.     

APPLICATION OF BORON MODIFIED SILICA SOL ON RETENTION AND DRAINAGE

INTRODUCTIONRecently with the high speed, large-scale develop-ment of papermaking, in the manufacture of paper and paperboard conventional single and dual reten-tion and drainage systems cannot obtain satisfying re-tention and drainage. So in 1980 microparticulate systems appeared. Because of its superiority such as good retention effectiveness on fine and chemicals, improving drainage and paper formation, reducing waste water and enhancing the concentration of white water for good recover…     

Nonsynchronous Trading Model and Return Analysis

Nonsynchronous trading is one of the hot issues in financial high-frequency data processing. This paper extends the nonsynchronous trading model studied in [1] and [2] for the financial security, and considers the moment functions of the observable return series for the extended model. At last. the estimators of parameters are obtained.     

A Dynamic Forecasting System with Applications in Production Logistics

Production logistics involve the co-ordination of ac tivities such as production and materials control (PMC), inventory management, p roduct life cycle management, etc. Those activities demand for an accurate forec asting model. However, the conventional methods of making sell and buy decision based on human forecast or conventional moving average and exponential smoothing methods is no longer be sufficient to meet the future need. Furthermore, the un derlying statistics of the market information change ...     

L-半胱胺酸自组膜修饰电极的制备及其电化学行为的研究

将L-半胱胺酸修饰到金电极表面,通过循环伏安法、阻抗法进行表征。在pH低时,高频部分的半圆的半径较pH高时的要大,其原因可能跟探针离子与L-半胱胺酸的静电作用有关。     

Pb-Sn-Bi三元系α相固溶体的点阵参数

应用X射线衍射法测定了Pb-Sn-Bi三元系Pb基α相固溶体的点阵参数,发现点阵间距与成分呈线性变化,对两批实验数据分别进行回归分析,得到点阵参数-浓度关系的统一解析式: α=0.49495X_(Pb)+0.47813X_(Sn)+0.50629X_(Bi)。其F检验置信度大于99.9％,残余标准差σ=6.4×10~(-5) nm,分析点阵畸变的影响因素表明尺寸效应是控制固溶体点阵行为的主要因素。     

异种钢焊接接头过渡层影响因素的研究

本文根据回归正交优化法原理,用电孤焊试验研究了异种钢焊接接头过渡层的影响因素。通过实测与计算,获得过渡层为零时,最佳匹配的焊接规范参数,为消除过渡层的有害影响探讨了新的途径。